Garmin mx 20 installation manual

Garmin ® and the Garmin the system allows manual steering For information about installing, see the installation instructions for each device. Device Overview. Select to place the autopilot in standby mode and return to the heading screen. Select to open a menu or perform the function listed above the key. MX20) Garmin AT GDL 69/69A (FIS) (Only one radar source may be connected to WSI InFlight AV (FIS) the MX20) (MX20 will communicate at 38, baud) Garmin GWX 68 Radar (MX20 I/O Model Only) Rev E MX20 Installation Manual. GTX 3X5 Transponder TSO Installation Manual Rev. 9 Page iii Record of Revisions Updated figure “Interface Group.” Added G NXi to description of REMOTE FMT 1 and REMOTE FMT 2 in table “RS

MX20 Typical Rear Panel Wiring Connections MX20 Installation Manual Rev E Page Electrical Connections Installation Electrical Connections The MX20 installation kit includes connectors and crimp contacts. First configure the MX20 for the ART option. Do this in the normal way by entering the install key sequence (1, 4, 6) on the menu keys after boot-up is complete. Enable fiRADARfl under the fiFUNCfl menu- set, then select the fiDATAfl menu-set and select the fiARTfl choice. To receive additional copies of this publication, order part # Rev C, MX20 Multi-Function Display Installation Manual. OTHER PUBLICATIONS MX20 Pilot’s Guide, P/N () MX20 Quick Reference Guide, P/N () GX50/60 Installation Manual, P/N () WX Installation Manual, Goodrich Avionics P/N

Transducer cable extensions are available through your Garmin dealer. Page 5. 3. GSD 20 Sonar Module. INSTALLATION INSTRUCTIONS. While following the instructions in this installation manual, install drain piping to ensure proper drainage and insulate piping to prevent condensation. 22 Remove and discard all pages of the manual and replace them with Garmin MX Display and Control, No Transponder Interconnect Diagram.